Outgoing Call; Pre-Dial; Post-Dial With Headset Button; Dial Using A Pre-Programmed Number - ASCOM d83 User Manual

Calling
End a Call
Press to end the call. The duration of the call is shown in the display. The total time of the call can also
be retrieved from the Calls menu → Call time.
Some systems/PBXs require that the handset sends a DTMF in order to end a call. For more
information, refer to the Configuration Manual, Ascom d83 DECT Handset, TD 93426EN.
5.3

Outgoing Call

5.3.1

Pre-Dial

1. Enter the number.
If needed, press Clear to erase the number. The Navigation key can be used it to step and add or
delete a digit in the middle of a number. The tone sender in a pre-dialled number can also be turned on
by long pressing
An international number can be dialled from the handset by entering a + character followed by the
country code and local number. To enter the + character, long press the 0 key until the character is
shown in the display.
2. Press or Call to get the line. The number is shown on the display while dialling.
5.3.2

Post-Dial with Headset Button

The headset button can be used to obtain a dial tone and dial a number. However, the headset must have
been configured via the WinPDM/Device Manager to allow this.
5.3.3

Dial Using a Pre-programmed Number

A Navigation key, Hot key, Soft key or Multifunction button can be programmed with a handset number, as
described in section 8.3 Shortcuts, page
number as long as it has been configured by the administrator via the WinPDM/Device Manager.
To dial a pre-programmed number, press the pre-programmed key or button. The call is connected
automatically.
5.3.4

Dial a Number from the Call list

1. Press when in idle mode or press Menu → Calls → Call list.
2. Select a number.
3. Press or Call to dial. The number can be edited before the call is started. Press More and select
Edit number.
5.3.5

Dial Last Called Number with Headset Button

If a headset is used, the headset button can be used to dial the last called number. However, the headset
must have been configured via the WinPDM/Device Manager to allow this.
5.3.6

Dial the Sender of a Message

You can call the sender of a message stored in the message list, from the Messaging menu.
1. Open the menu by pressing the soft key Menu.
2. Select Messaging → Inbox.
28
.
60. A headset button can also be programmed with a handset
Ascom d83 DECT Handset
TD 93434EN / 01 December 2021 / Ver. B
USER MANUAL