Canon N 1000 Setup Manual page 96

2-10
Installing Options
If 10BASE-T is in use, LNK lamp (b) should light.
If 100BASE-TX is in use, LNK lamp (b) and the 100 lamp (a) should light.
If the LNK lamp does not light or if it is flashing, check the following:
• Is the HUB switched on?
If the HUB is switched off, switch it on.
• Is the LAN cable connected securely?
Confirm that the LAN cable connectors are clicked and locked in
place securely.
• Is the LAN cable defective?
Connect another LAN cable and visually check the LNK lamp
again.