Canon N 1000 Setup Manual page 25

3
Connect the other end of the LAN cable to a standard port on the
HUB.
Press in until you hear a click.
4
Connect the power cord ( P.1-14), press the Power button on the
printer operation panel to switch the printer on, then visually check
the lamps on the network interface board.
If 10BASE-T is in use, LNK lamp (b) should light.
If 100BASE-TX is in use, LNK lamp (b) and the 100 lamp (a) should light.
If the LNK lamp does not light or if it is flashing, check the following:
• Is the HUB switched on?
If the HUB is switched off, switch it on.
• Is the LAN cable connected securely?
Confirm that the LAN cable connectors are clicked and locked in
place securely.
• Is the LAN cable defective?
Connect another LAN cable and visually check the LNK lamp
again.
1-13
3 Connect the Computer