Completion Of The Operation - NUVE BM 15 Instruction Manual

See "t ın" on the temperature display. Set the time value by pushing the
value increase/decrease keys on the time adjustment side (1 minute to 99.9
hours or Hold)
Push the time set key again.
See "dly" on the temperature display. Set the delay time, after which the
program starts, by pushing the value increase/decrease keys on the time
adjustment side (1 minute to 99.9 hours or Hold)
Push the start/stop key to start the program.

The set time start to count after the device reaches the set temperature.

6.3. COMPLETION OF THE OPERATION

 Ensure that the program is over.
 If there is no adjusted program, you can terminate the heating process by pushing start/stop
button.
 Take the samples out at the end of the operation. Take precautions while handling the
samples after the operation as they can be hot.
 Remove the undesirable effects occurred during the operation after the tank has been
completely emptied.
 You may leave the bath at stand-by or switch it off.
Push the time set key again to save the settings.
13