Prior To Operation; Filling Liquid - NUVE BM 15 Instruction Manual

1- Heating Process Display: This display shows the tank temperature during the operation and
the set temperature value during programming. The error codes are also shown on this
display.
2- Time Display: This display shows the elapsed time during the operation and the set value
during programming.
3- Alarm Mute Key: This key is used to mute the alarm which sounds when the program ends
and if any failure occurs during the operation.
4- Start / Stop Key: This key is used to start the program or to stop the running program
manually.
5- Temperature Set Key: This key is used to set the temperature
6- Temperature Value Increase/Decrease Keys: These keys are used to increase or decrease
the values on the temperature display.
7- Time Set Key: This key is pushed to set the time. (1 minute – 99.9 hours and Hold position).
8- Time Value Increase/Decrease Keys: These keys are used to increase or decrease the values
on the displays.
9- Heat Led: This led flashes during heating process.
10- Alarm Led: It turns on when the program ends and if any failure occurs during the operation.

5.8. PRIOR TO OPERATION

5.8.1. FILLING LIQUID

Fill the tank with distilled water or liquid and put the samples up to the maximum line MAX (see
Figure 4). Undesired problems may occur if you fill up to the level lower than the max level.
Do not run the device unless distilled water or liquid is fılled up to max line.
The distilled water or liquid level above the max level may cause unexpected
problems.
Make sure that the filled liquid is not flammable or explosive at the operation
temperature.
When you start the device, circulation may not be observed, if there is residual air in
the pump in order to remove the residual air, disconnect the device from mains and
restart it.
11