Assembly Instructions (Continued)
Attach the 8" Outlet Adapter (E) onto the
7
outlet of the Fan Housing (B) with four Hex
Head Bolts (O9), eight Flat Washers (O5), and
four Whiz-Lock Nuts (O6) as shown in [FIG.
7].
Note: Tighten rmly but do not over compress
the gasket.
Open two 8" Duct Clamps (G) and slip them
8
over the Plenum Extension (F) [FIG. 8a].
Mate the Plenum Extension to the 8" Outlet
Adapter (E) then the Elbow (H) and close the
Clamps over the rolled ends.
Open two 8" Duct Clamps and slip them over
the Plenum Extension [FIG. 8b]. Mate the
Plenum Extension to the Elbow (H) then the
8x7x7 Pants Wye (I) and close the Clamps over
the rolled ends.
Lock the Clamps in place using the provided
cotter pins [FIG. 8c].
12 Oneida Air Systems
FIG. 7
FIG. 8a
FIG. 8b
FIG. 8c