Oneida Air Systems 8491685 Owner's Manual page 15

High vacuum dust collector with smart boost and air lock

Table of Contents

Assembly Instructions (Continued)

Attach the Dual Filter Plate (L) to the stand

using the stand's pre-installed hardware as

shown in [FIG. 9].

Note: Hardware should be nger tightened rst

for ease of assembly when securing Filter Plate

Assembly.

Bolts

Washers

Whiz-Lock Nuts

FIG. 9

Cut the 7" Diameter Flex Hose (K) in half

using a razor knife and diagonal cutter to cut

Cut

Here

through the clear lining and reinforcing wire.

[FIG. 10a].

Attach both pieces of 7" Diameter Flex Hose

to the 8x7x7 Pants Wye (I), and secure them

FIG. 10a

in place with the 6-8" Hose Clamps (J). Repeat

the process to attach the opposite end of each

Hose onto the openings on the Dual Filter

Plate (L) [FIG. 10b].

Note:

e hose is a snug t. Pull ends up little by

little to work the hose onto the Pants Wye and

Dual Filter Plate. Pliers can be used to grab the

reinforcing wire and aid in pulling the hose

over the opening.

FIG. 10b

oneida-air.com

Table of Contents

8496719 7247180