Oneida Air Systems 8491685 Owner's Manual page 11

Assembly Instructions (Continued)
Apply Gasket (O1) making sure that there is
2
no gap where the ends meet:
a. Apply to the top ange of the Cone (D)
inside the bolt holes [FIG. 2a].
b. Apply to the top rim of the Barrel (C)
outside of the bolt holes [FIG. 2b].
c. Apply to the Fan Housing's (B) outlet
inside the bolt holes [FIG. 2c].
d. Apply to the top of the Fan Housing (B)
outside the bolt holes [FIG. 2d].
Note: Dust collection systems cannot operate
e ectively if there isn't a complete seal.
must be NO air leaks.
Li the Cone (D) onto the Stand (P), making
3
sure to align the Cone's ange holes with those
on the Stand [FIG 3].
Top View
FIG. 2a
ere
FIG. 2c
Top View
FIG. 2b
FIG. 2d
FIG. 3
oneida-air.com 9