List Of Warning Information - Siruba BH9820 Operation Manual

5 Appendix 1

5.1 List of Warning Information

Malfunction
Name of Malfunction
number
E-001 IPM over-voltage or over-current
Supplementary device (24V)
E-002 over-voltage
Supplementary device (24V)
E-003 low-voltage
E-004 EEPROM Error
E-005 Motor running error
E-006 Press Pause key at standby status
E-007 Press Pause key at sewing status
E-008 Pause Key bad connection
Start Switch is held or bad
connection
E-009
Presser Switch
E-010 connection at presser switch
E-011 Machine head is tilted.
E-012 Needle upper position abnormal
Synchronization signal detector
bad
E-013
Cannot find X feeding motor origin. X
feeding motor abnormal or bad
connection at X origin sensor
E-014
Cannot find Y feeding motor origin. Y
feeding motor abnormal or bad
E-015 connection at Y origin sensor
Cannot find θ feeding motor origin.
θ
feeding motor abnormal or bad
E-016
E-017 IPM Over-current
E-018 IPM Over-current
Program version of main controller
or
E-019
E-020 Upper thread-breakage
Bottom thread-trimming device not
work or bottom thread-
trimming sensor abnormal
E-021
Hammer is lowered or hammer
position sensor is abnormal
E-022
Hammer is not lowered or
hammer
E-023
E-024 Power over-voltage
E-025 Stepping motor over-voltage
E-026 Power low-voltage
E-027 Stepping motor over-current
System Malfunction
Special Malfunction
Release the start switch or turn off
machine. And check the connection
is held or bad Release the start switch or turn off
machine. And check the connection
35
Method for Settlement
Turn Off Machine
Turn Off Machine
Turn Off Machine
Turn Off Machine
Turn Off Machine
Release pause key
Press RESET
Turn Off Machine
Turn Off Machine
Turn wheel to upper position
Turn Off Machine
Turn Off Machine
Turn Off Machine
Turn Off Machine
Turn Off Machine
Turn Off Machine
Turn Off Machine
Press RESET
Turn Off Machine
Turn Off Machine
Turn Off Machine
Turn Off Machine
Turn Off Machine
Turn Off Machine
Turn Off Machine