Siruba BH9820 Operation Manual page 30

⑦ Press to select C1, the
pattern number of that cyclical
pattern program
The pattern number will change
in the following sequence: P01 → P02
→...P20→C1→C2...C9...P01 at each
pressing of . (Press
reverse the sequence.)
⑧ Press Cycle Mode Key (2)
The sewing data display area will
show the following contents:
（3）Step Number
（4）Cyclic Program Number
（5）Pattern Content Set in S1.
⑨ Press to set the content
of S1 (5) as P01
The underline " _" in "P01"
means that this pattern has the cutter
action, therefore the cutter mark (6) is
shown in the sewing data display area
"--" in "P--" means the pattern
in this step has not been set yet.
If you set the existing pattern as
"P--", the content of the following
steps will be deleted.
⑩ Press to confirm
changed content.
At that time, the content of S1 (5)
will not be flashing any more.
⑮ Press
to change the step
⑯ Repeat the operations in the above
number（3）to S2.
steps 4 & 5 to set the content of
S2
as "P01", which is the same as
that of S1. Also set the content of
S3 as "P01", which is the same as
that of S1.
⑰ Press
to confirm
changed content.
to
the
the
22