Description Of Front Panel Controls - Air Liquide Oerlikon CITOLINE 2500M Safety Instruction For Use And Maintenance

EN
4. Secure the wire guide tube, and ensure that the diameter cor-
responds to the wire used.
5. Refit the gas nozzle.
6. Open the gas cylinder valve.
7. Connect the ground clamp to the workpiece on a section free
of rust, paint, grease or plastic.
3.0 DESCRIPTION OF FRONT PANEL CON-
TROLS
VERSION MS
Picture 1.
13
11
10
PULLING SET
Picture 2.
1
5
6
7
15
16

DESCRIPTION OF FRONT PANEL CONTROLS

14
12
9
2
3
4
8
VERSION M
Picture 3.
1
5
6
7
8
9
1. Welding system selector (Ref. 1 - - Picture 3 Page 5. - -
Picture 2 Page 5.):
In position press the torch button to start welding, and
release to stop.
In position press the torch button to deliver gas; on re-
lease, wire feed and current are activated; press again to stop wire
feed and current and release to shut off the gas supply.
In position the welder operates in timed mode; press the
torch button to start the welding phase, which stops automatically
after the time interval as set on the timer potentiometer.
2. Machine ON indicator lamp (Ref. 2 - Picture 3 Page 5. -
Picture 2 Page 5.)
3. Machine overheated or anomaly warning light (Ref. 3 -
Picture 3 Page 5. - Picture 2 Page 5.).
4. Wire feed speed control -potentiometer (Ref. 4 - Picture 3
Page 5. - Picture 2 Page 5.)
5. Spot welding time control potentiometer, from 0.3 to 10
seconds. Operating only with selector (Ref. 1 - - Picture 3
Page 5. - - Picture 2 Page 5.) set to position
6.
Wire feed motor acceleration time control potentiometer
(Ref. 6 - - Picture 3 Page 5. - Picture 2 Page 5..
7. Control potentiometer to regulate time during which
welding power is maintained after the relative shutdown
signal (Ref. 7 - - Picture 3 Page 5. - Picture 2 Page 5.). In
practice, at the end of welding, if this time is too short, the
wire remains stuck in the bath or protrudes too far from the
torch contact tube; otherwise, if the control time is too long,
the wire remains stuck in the torch contact tube, often caus-
ing damage to the latter.
8. Euro torch connector (Ref. 8 - - Picture 3 Page 5. - Picture
2 Page 5.)
9. Earth cable socket
10. Power button.
5 EN
2
3
4
16
15
11
10