Controller Firmware Download And Installation - Kohler OnCue Plus RDC Operation

1.8 Controller Firmware Download
and Installation
It may be necessary to update the firmware on your
generator set controller. See Figure 1-6 for the firmware
version required for your device. Refer to the generator
set documentation for instructions to find the version
number installed on your controller.
Note: Controller firmware can be updated by a Kohler
authorized distributor or dealer using a personal
computer and Kohlerr SiteTecht software. The
Kohler OnCuer Plus application cannot be used
to update controller firmware.
Model
6VSG
6VSG w/comm. kit
14/20RES
14/20RESL
14/20RESA
14/20RESA with APM
14/20RESAL
38RCL
48RCL
* This firmware version number or higher is required.
[ #_#_# in the file name is the firmware version number.
Figure 1-6 Controller Firmware Version Numbers and File Names
14 Section 1 System Information and Installation
Controller Firmware Version Number *
VSC
VSC
RDC
DC
RDC2
RDC2
DC2
RDC2
RDC2
Firmware Version Numbers
Software and firmware version numbers consist of three
parts separated by periods (or dots) as follows:
[Major version number].[Minor version number].[Build number]
For example, if the version number is 2.3.17, the major
version number is 2, the minor version number is 3 and
the build number is 17. The build number is typically not
shown on the controller display, but is included in the
firmware file name.
Preceding zeros may be dropped from version numbers
for software and firmware.
version 2.3 is the same as version 2.03. However,
version 2.1 (two point one) is not the same as 2.10 (two
point ten).
1.00
1.02
3.00
3.00
4.03
105.04
4.03
4.10
4.03
For example, firmware
Firmware File Name
[
VSC_#_#_#.bin
VSC_#_#_#.bin
RDC_#_#_#.bin
RDC_#_#_#.bin
RDC2_#_#_#.bin
RDC2_###_#_#.bin
RDC2_#_#_#.bin
RDC2_#_#_#.bin
RDC2_#_#_#.bin
TP-6928 1/14