Rdc/Dc Controller - Kohler OnCue Plus RDC Operation

1.7.3

RDC/DC Controller

The RDC/DC generator set controller must be equipped
with the Ethernet option board, which allows connection
of the generator set to the Internet through a broadband
Internet connection. The Ethernet option board is
included in the OnCuer Plus kit for the RDC/DC
controller. See instruction sheet TT-1566, included with
the OnCue Plus kit, for Ethernet option board installation
and connection instructions. See Figure 1-5.
When the Ethernet board is installed, update the
RDC/DC controller firmware and follow the instructions
Kohlerr generator set
RDC or DC Ethernet
Controller Board[
* Customer-provided. Router and modem may be combined in one box.
[ Ethernet board kit is required.
Figure 1-5 Typical Connections for RDC/DC Controller
TP-6928 1/14
Ethernet cables *
Router *
in TT-1566 to record the controller password and
generator set serial number for entry into the OnCue
Plus application.
In most cases, once the new firmware is uploaded to the
controller and the Ethernet board is connected to the
customer's router or modem, the controller will
automatically connect to the Kohler OnCue Plus server.
Controller settings and network router adjustments are
usually not required. The Internet connection between
the controller and the Kohler OnCue Plus server is fully
encrypted for your protection.
OnCue Plus
Cable or
Server on the
DSL
Modem *
UPS *
(optional)
Section 1 System Information and Installation
Tablet *
Remote
PC *
Internet
Smart phone*
G6-116
13