Nameplate Serial Number - Kohler OnCue Plus RDC Operation

Status
Display
Press down arrow multiple times.
Networking---->
Information
Figure 1-7 Finding the Serial Number and Password, RDC2 and VSC Controllers
1.9.4

Nameplate Serial Number

Verify that the serial number shown on the controller
display matches the serial number on the generator set
nameplate. A typical nameplate is shown in Figure 1-8.
Refer to the service views in the generator Operation
Manual for the location of the nameplate, if necessary. If
the serial numbers on the controller display and the
generator nameplate do not match, contact your
distributor or dealer.
16 Section 1 System Information and Installation
Networking---->
Status
Networking
Reset OnCue
Configuration
Password
DHCP:
Enabled
<---- Return
HOLD
Reset OnCue
Password? No
Reset OnCue
Password? Yes
S/N: 1234567
New PW: 1234
1. Generator serial number
Figure 1-8 Generator Nameplate, Typical
UP arrow for YES,
Down arrow for NO.
New S/N and password are
displayed for approximately
10 seconds.
tp6926
1
TP-6928 1/14