General Safety Instructions - Nakayama MB5000 Owner's Manual

General Safety Instructions

Prior to the initial use of the unit, the operating instructions should be read completely. If in doubt with regard to connection
and operation of the unit, consult the manufacturer (Servicing Department)
FOLLOW THE INSTRUCTIONS BELOW CAREFULLY IN ORDER TO SECURE A HIGH DEGREE OF SAFETY:
CAUTION!
1. Pay attention to the conditions of the area, which you're working in. After the engine is started, power machine will
produce poisonous flue gas. The gas may be invisible and odorless. Hence never work with the machine closed or poorly
ventilated areas. Provide for good lighting when cutting. Provide for stability when cutting in wet, snow or icy weather
conditions on slopes or rough ground.
2. Do not let any unauthorized persons approach the machine. The visitors and viewers, primarily the children, the ill and
infirm persons should not have any access to the working area. Prevent other persons from any contact with the machine.
3. Make provision for the tools storage. The machines not in current use should be kept in a dry place, elevated or locked
where practicable so that any access to them is prevented.
4. Always use a correct tool for the job to be done. E.g. avoid using small tools and accessories for work that should be
actually done with a heavy tool. Use the tools only for the purposes they were designed for.
5. Pay attention to adequate clothing. The clothing should fit the purpose and should not put any limits to you when
working.
6. Use personal protection equipment. Wear safety shoes with steel toes and antiskid or rough sole.
7. Wear goggles. Object may be thrown against you.
8. Wear ear protectors. Wear personal protective equipment to protect your ears, such as ear protectors.
9. Hand protection. Wear hard gloves-gloves of chrome tanned side leather give a good protection.
10. Transport. The tiller should be always transported with the driving wheel in transport position. Make sure that nobody is
exposed to risk when the tiller is put out of service. Secure the unit against tilting, damage and fuel leakage.
11. Remove the wrench etc. Any wrenches/spanners etc. must be removed before the tiller is put on.
12. Be attentive any time. Mind what you are doing. Use common sense. Do not use the tiller when tired. Never work with
the crusher when influence by alcohol, drugs or medicaments affecting the concentration capability.
13. Refueling. Always switch the engine off before refueling. Open the tank closure carefully for overpressure run out slowly
and the fuel ejection is prevented. When working with the tiller, the unit body temperature increased. Let the unit cool
down before refueling. Otherwise, the fuel could ignite and persons get burnt. Beware of overfilling the tank. If there is a
3
Scope of Delivery
1. Carriage
2. Left-hand handle (driving lever)
3. Driving lever
4. Depth limiter
5. Bracket and handle
6. Wheel
7. Right-hand handle (ON/OFF, SPEED)
.N
WWW AKAYAMA
T .
OOLS COM