Nakayama MB5000 Owner's Manual page 6

Switching unit on/off
Put the lever on the chute (Fig 12). Pull the starter cable
evenly. The engine should start up after 3-5 pulls. Put the
lever at the required speed and pull the driving lever (Fig.
12) against the handle (Fig. 13)
Notice: If the engine is heated up, it is possible to start up
in the slow/fast position.
With the driving lever tripped, the drive will be off but the
engine works on. The engine may be switched off with the
switch in OFF position (Fig. 12)
Operator Safety Instruction
* Do not use the machine until you have read the instruction manual carefully.
* Observe any safety instruction included in the manual.
* Be responsible to the others
* The unit is provided a foot-operated brake than stops the blades within 3 seconds after the drive lever tripping. Never
attempt stopping the unit or tilting the unit with blades still rotating. Wait for the blades to come stand by themselves.
* If the blades get in touch with foreign objects, stop the engine immediately and check the unit with blades stopped for
damage. Continue working with unit undamaged only.
* Walk while working and do not run.
* Always walk forward only. Never pull the unit walking backwards.
* When working on a slope, always work across, never down and up. Be particularly careful when changing direction.
* When travelling across no-grass areas and transferring the unit from the work area to another one, the blades must not be
operating.
Step-by-Step Instructions
1. Fill in the fuel (see chapter Assembly and First Putting In Operation)
2. Clear any foreign objects from the land.
3. Spud the land until the soil is sufficiently loose.
4. Clean the unit thoroughly after every use.
6
.N
WWW AKAYAMA
Cutting height setting
Shifting the depth limiter shall set up the required depth of
tilling. 3 different positions are possible
T .
OOLS COM