Specifications - Banner WORLD-BEAM QS18E Instruction Manual

®
WORLD-BEAM QS18E Clear Object Detection with IO-Link

6 Specifications

Supply Voltage and Current
10 V dc to 30 V dc (10% max. ripple) at 30 mA
Repeatability
100 µs
Supply Protection Circuitry
Protected against reverse polarity and transient overvoltages
Output Protection Circuitry
Protected against false pulse on power-up and continuous overload or
short-circuit of output
Output Configuration
Channel 1: IO-Link, Push/pull output, configurable PNP or NPN output
Channel 2: Multi-function remote input/output, configurable PNP or
NPN
Output Response Time
Momentary delay on power-up, < 0.5 s, output does not conduct
during this period
400 µs ON/OFF
IO-Link Interface
Supports Smart Sensor Profile: Yes
Baud Rate: 38400 bps
Process Data Widths: 16 bits
IODD Files: Provides all programming options of button and remote
input wire, plus additional functionality. Please see the IO-Link
Datamap document for more details.
Required Overcurrent Protection
WARNING: Electrical connections must be made
by qualified personnel in accordance with local
and national electrical codes and regulations.
Overcurrent protection is required to be provided by end product
application per the supplied table.
Overcurrent protection may be provided with external fusing or via
Current Limiting, Class 2 Power Supply.
Supply wiring leads < 24 AWG shall not be spliced.
For additional product support, go to www.bannerengineering.com.
Supply Wiring (AWG)
20
22
24
26
28
30
14
Required Overcurrent Protection (Amps)
5.0
3.0
2.0
1.0
0.8
0.5
www.bannerengineering.com - Tel: 763.544.3164
Emitter LED
Visible red, 625 nm
Indicators
Two LEDs (1 green, 1 amber)
Green solid: Indicates power applied and sensor ready
Green flashing: Indicates sensor operating in marginal state, in need
of reconfiguration
Amber solid: Indicates output conducting
Factory Default Settings
Setting
Sensing Mode
Output Logic
Offset Percent
Push Button
Auto Compensation
OFF Delay
Pin 4 Output
Pin 2 Output
Construction
ABS housing, PMMA window
Mounting Torque
Nose mount: 18 mm mounting nut, 20 Ibf·in (2.3 N·m)
Side mount: Two M3 screws, 5 Ibf·in (0.6 N·m)
Connections
PVC-jacketed 4-conductor 2 m (6.5 ft) or 9 m (30 ft) unterminated
cable, or 4-pin Euro-style or 4-pin Pico-style quick-disconnect (QD),
either integral or 150 mm (6 in) pigtail, are available. QD cordsets are
ordered separately.
Operating Conditions
−40 °C to +70 °C (−40 °F to +158 °F)
95% at +50 °C maximum relative humidity (non-condensing)
Environmental Rating
IEC IP67
Application Notes
If the push button does not appear to be responsive, perform the push
button enable procedure
Certifications
Factory Default
Transparent Mode
Dark Operate
16%
Unlocked
Disabled
Disabled
IO-Link Enabled Detection Output (Push-pull)
Detection Output: High speed output when
using IO-Link on Pin 4 (PNP)