Pa-5200 Front Panel - PaloAlto Networks PA-5200 Seriesp Hardware Reference Manual

PA-5200 Series Firewall Overview

PA-5200 Front Panel

The following image shows the front panel of the PA-5200 Series firewall and the table describes
each front panel component. The only differences between the PA-5220 (shown), PA-5250,
PA-5260, and PA-5280 panels is the model name and the Ethernet port speeds as described in the
table.
Item Component
1 Ethernet ports 1 through 4
2 SFP ports 5 through 20
3 QSFP+ ports 21 through 24
4 HSCI port
PA-5200 Series Next-Gen Firewall Hardware Reference
Descripon
Four RJ-45 100Mbps/1Gbps/10Gbps ports for
network traffic.
The link speed and link duplex are auto-
negoate only.
Sixteen SFP/SFP+ ports for network traffic.
Each port can operate as either SFP (1Gbps)
or SFP+ (10Gbps) based on the installed
transceiver.
These ports vary depending on your firewall
model:
• PA-5220 firewall—Four 40Gbps QSFP+ ports
as defined by the IEEE 802.3ba standard.
• PA-5250, PA-5260, and PA-5280 firewalls—
Four 40Gbps QSFP+/100Gbps QSFP28
ports as defined by the IEEE 802.3ba
standard. The link speed is based on the
installed transceiver.
These ports vary depending on your firewall
model:
• PA-5220 firewall—One QSFP+ 40Gbps port
(supports only a 40Gbps (QSFP+) transceiver
or QSFP+ acve opcal cable).
• PA-5250, PA-5260, and PA-5280 firewalls
—One QSFP28 40/100Gbps port (supports
40Gbps (QSFP+) or 100Gbps transceiver
(QSFP28) or equivalent acve opcal cables).
The link speed is based on the installed
transceiver. Use this port to connect two
14
2021 Palo Alto Networks, Inc.
©