PA-220R Firewall Overview
PA-220R Front Panel
The following image shows the front panel of the PA-220R firewall and the table describes each
front-panel component.
Item
Component
1
Screw-on ground point
2
DC power and ground inputs
3
Ethernet ports 1 through 6
4
SFP ports 7 and 8
5
MGT port
6
CONSOLE port (RJ-45)
PA-220R Next-Gen Firewall Hardware Reference
Descripon
Use this ground point to connect the firewall to
earth ground (ground cable not included).
Use the DC input terminal block to connect DC
power to the firewall. The terminal block is included
in the accessories kit and is labeled A+, A-, B+, and
B-.
The two inputs to the right of the four DC power
inputs are ground inputs (use only one) that you can
use in place of the screw-on ground point on the
firewall (see
Connect Power to a PA-220R
Six RJ-45 10Mbps/100Mbps/1000Mbps ports
for network traffic. You can set the link speed and
duplex or choose auto-negoate for each port.
These ports also have built-in surge protecon.
Two SFP (1Gbps) ports for network traffic.
These ports also support 100Base-FX.
Use this Ethernet 10Mbps/100Mbps/1000Mbps
port to access the management web interface and
perform administrave tasks. The firewall also
uses this port for management services, such as
retrieving licenses and updang the threat and
applicaon signatures.
Use this port to connect a management computer to
the firewall using a 9-pin serial-to-RJ-45 cable and
terminal emulaon soware.
14
Firewall).
2021 Palo Alto Networks, Inc.
©