Connect Ac Power To A Pa-5200 Series Firewall - PaloAlto Networks PA-5200 Seriesp Hardware Reference Manual

Connect Power to a PA-5200 Series Firewall

Connect AC Power to a PA-5200 Series Firewall

The following procedure describes how to connect AC power to a PA-5200 Series firewall with AC
power supplies.
To avoid injury to yourself or damage to your Palo Alto Networks
that resides on the hardware, read the
STEP 1 | Remove the two nuts and star washers from the ground studs on the back of the firewall and
then remove the two-hole ground lug.
STEP 2 | Crimp a 6AWG ground cable (not included) to the two-hole 6AWG ground lug and then
aach the ground lug to the ground studs on the firewall. Replace the star washers and nuts
and torque to 25 in-lbs. Connect the other end of the cable to earth ground.
STEP 3 | Connect the AC power cord to power input 1 (PWR 1) and connect a second power cord to
power input 2 (PWR 2).
STEP 4 | Secure the power cords to the power supplies using the Velcro straps.
STEP 5 | Connect the other end of the power cords to an AC power source. Aer the first power
supply is connected, the firewall powers on and the power LED on the power supply and the
PWR LED on the front of the firewall turns green.
Connect the second power cord through a different circuit breaker to provide power
redundancy and to allow for electrical circuit maintenance.
PA-5200 Series Next-Gen Firewall Hardware Reference
Product Safety Warnings.
24
hardware or the data
®
2021 Palo Alto Networks, Inc.
©