Table of Contents
Advertisement
Security devices
Emergency stop :
The POWEO® 150 is equipped with an
emergency stop button that will power off the lifter
when pressed.
The emergency stop button is located on the
battery top.
Once pressed It must be turned clockwise or
counter clockwise in order to reset it
Emergency lowering devices :
If the battery goes flat during a lift, there is at least
enough power to lower the patient down again.
In case of non-operation of the remote control,
an emergency electric lowering is still possible
by operating the hidden button located behind
the yellow label of the base.
Perforate the centre of the yellow sticker and
press the hidden button with a small
screwdriver: the lifter will perform a emergency
lowering. Maintain the pressure on the button
to obtain the wanted height.
In case of a complete failure of electronics, a
MANUAL emergency lowering is available.
Activate the RED lever/trigger on the actuator,
by pulling it upward, and maintain the position
until the actuator reaches the desired height.
Lowering speed will depend on the charge and
the pressure on the trigger.
According to the EN 10535 standard, the POWEO® 150 will not function with a patient
weighing more than the maximum load of the lifter.
The value is set to 160kg +/- 10kg.
For the SCALIS equipped version, and because the Max of the scale is set also to 150kg
the scale will display a "> MAX !" message to indicate that the lifter is overloaded.
The opening of the legs is also secured : in the case of a contact between a leg and an
obstacle, the legs will automatically stop moving.
The leg opening movement stop is therefore a warning for the user: it means that the
security device is operating, so the transfer of the patient is not secured..
USING THE POWEO® 150
Advertisement
Table of Contents
