Omron FH Series Hardware Setup Manual page 53

Component Names and Functions
(A)
(B)
(C)
(D)
(E)
(F)
Connector name
(A) SD memory card
installation con-
nector
(B) Ethernet connec-
tor
(C) USB connector
(D) RS-232C connec-
tor
(E) DVI-I connector
(F) I/O (Parallel) con-
nector (control
lines, data lines)
(G) EtherCAT address
setup volume
FH Series Vision System Hardware Setup Manual for 3D Robot Vision (Z436-E1)
(G)
(H)
(I)
(J)
(K)
(L)
Install the SD memory card. Do not plug or unplug the SD memory card during
measurement operation. Otherwise measurement time may be affected or data
may be destroyed.
Connect an Ethernet device.
Upper port :
Ethernet port
Lower port :
Ethernet port, EtherNet/IP port, and PROFINET port
are sharing use.
Connect the camera cable (Ethernet cable FHV-VN£BX: sold separately) to the
upper port.
Connect a USB device.
Do not plug or unplug it during measurement. Otherwise measurement time may
be affected or data may be destroyed.
Left ports: USB2.0
Right ports: USB3.0
The USB3.0 interface has a higher bus power supply
capability than the USB2.0 interface, and you can expect
more stable operation with it.
Also, when used in combination with a USB3.0 device, you
can expect higher transfer speed than USB2.0.
Be sure to give priority to using the USB3.0 interface.
Connect an external device such as a touch panel monitor.
Connect a monitor.
Connect the controller to external devices such as a sync sensor and PLC.
Used to set a station address (00 to 99) as an EtherCAT communication device.
3 Configuration
Description
3
3-5