Table of Contents
Advertisement
SAFETY SIGNS
·
The safety signs reproduced below appear on the header at the locations listed.
·
Keep safety signs clear and legible at all times.
·
Replace safety signs that are missing or become illegible.
·
If original parts on which a safety sign was installed are replaced, be sure the repair part also bears
the current safety sign.
·
Safety signs are available from your Dealer Parts Department. The part number is printed in the
lower R/H corner of each safety sign.
To install safety signs:
1. Be sure the installation area is clean and dry.
2. Decide on the exact position before you remove the backing paper.
3. Remove the smaller portion of the split backing paper.
4. Place the sign in position and slowly peel back the remaining paper, smoothing the sign as it is
applied.
5. Small air pockets can be smoothed out or pricked with a pin.
Form # 46620
SAFETY
6
Issue 11/06
Advertisement
Table of Contents
