Table of Contents
Advertisement
ATTACHING THE HAY CONDITIONER (continued)
7. Install belt over pulley (M) on header drive
shaft. *
NOTE: Do not pry belt over pulley. Loosen or
remove spring-loaded idler to allow installation.
(If idler is removed, take note of hardware
positioning for re-assembly.)
* IMPORTANT: Before first use, position drive
pulley (M) on shaft to align the belt. See
"Attaching the Hay Conditioner" in Assembly
section.
8. Adjust belt tension. See "Hay Conditioner Drive
Belt" in Maintenance/Service section.
9. Attach header to tractor. See Windrower
Tractor or Adapter Operator's manual.
10. Attach forming shield rear support straps to
lower brackets at (N).
NOTE: See Assembly section for instruction
regarding
attaching
conditioner and/or tractor.
11. Adjust header float springs for additional
weight. See Windrower Tractor or Adapter
Operator's manual.
Form # 46620
OPERATION
forming
shields
to
M
INSTALL BELT AND ADJUST TENSION
ATTACH FORMING SHIELD REAR SUPPORTS
15
N
Issue 11/06
Advertisement
Table of Contents
