Table of Contents
Advertisement
PREPARE TO UNLOAD
CAUTION:
bystanders from being struck by
machinery, do not allow persons to
stand in unloading area.
1. Move trailer into position and block trailer
wheels.
2. Lower trailer storage stands.
CAUTION:
must meet or exceed specified
requirements.
equipment may result in vehicle
tipping, chain breakage, or machine damage.
LIFTING VEHICLE REQUIREMENTS
Use a lifting vehicle with minimum 4600 lb. (2085
kg) lifting capacity.
CHAIN REQUIREMENTS
Use overhead lifting quality chain (1/2 in.) with
minimum 5000 lb. (2270 kg) working load limit.
UNLOAD HEADER
CAUTION: Be sure header is secure
on forks before moving away from
load. Stand clear when lifting.
1. Drive lifting vehicle to position forks under
frame tube and feed pan as shown at (A).
2. To prevent header from sliding back and
contacting forklift mast, stack four 2 x 4's (two
wide and two high) at rear of forks as shown at
(B).
3. Remove hauler's tie down straps and chains.
4. Raise header and remove from trailer.
5. Take to storage or set-up area.
6. Set machine down securely on level ground,
leaving forks in place. Check for shipping
stand damage and damaged or missing parts.
7. Lower forks and back away from unit.
8. Remove
any
attachments
cutterbar.
Form # 46620
UNLOADING & ASSEMBLY
To
avoid
injury
to
Unloading
equipment
Using
inadequate
wired
under
PREPARE TO UNLOAD
A
UNLOAD HEADER
68
B
Issue 11/06
Advertisement
Table of Contents
