Table of Contents
Advertisement
Installation
It is dangerous to alter the specifica-
tions or attempt to modify this prod-
uct in any way.
Care must be taken to ensure that
the appliance does not stand on the
electrical supply cable.
Any electrical work required to install this
appliance should be carried out by a qual-
ified electrician or competent person.
Important:
The appliance must not bulit-in.
Unpacking
Slide out the polythene
bag with the polystyrene
stuffing before using the
appliance Pull off adhesive
strips from inside machine
on top of drum.
P1106
Should the appliance be moved, it must be
transported vertically.
The appliance must not be installed behind a lockable
door, a sliding door or a door with a hinge on the
opposite side to that of the appliance.
Positioning
It is recommended that, for your convenience, the
machine is positioned close to your washing
machine. Whilst drying, the tumble dryer will
expel a certain amount of warm, very moist air,
and this should be removed from the room as
quickly as possible to prevent condensation. In
an extremely well ventilated room or close to an
open window, this may occur naturally. However,
in general, it is better to carry the dryer's exhaust
outside via the 100 mm diameter flexible hose
supplied with the appliance; ending either
temporarily at an open window, or permanently at
18
All manuals and user guides at all-guides.com
P1028
a fixed ventilation grille, fitted to an exterior wall
or window. The tumble dryer must be installed in
a clean place, where dirt does not build up. Make
sure there are no obstructing items or material
near the air-intake louvres provided at the back
(e.g. paper, rags etc.). To keep vibration and
noise to a minimum when the dryer is in use, it
should be placed on a firm, level surface. Once in
its permanent operating position, check that the
dryer is absolutely level with the aid of a spirit
level. If it is not, raise or lower the feet until it is.
P0046
Important
When operating the tumble dryer, the room
temperature must not exceed 35°C, as it may
affect the performance of the appliance.
Fitting the vent hose
To simplify the installation, there is a choice of
vent outlets: one at the back, the others in the left
and right-hand side. Connect the hose to
whichever is the more convenient by pulling the
ring nut (A) from the vent outlet at the back,
screwing it on to the hose and pushing it firmly
back into place. The unused vents should now be
sealed with the special snap covers provided.
A
Advice: If the hose is long and the room
temperature low, the moisture might condense to
water inside the hose. This is an unavoidable
The feet must never be
removed. Do not restrict
the floor clearance through
deeppile carpets, strips of
wood or similar. This might
cause heat build-up which
would interfere with the
operation of the appliance.
A
P1027
Advertisement
Table of Contents
