Table of Contents
Advertisement
Exhaust Venting
ˆ Free-flowing, clear of lint buildup
ˆ 4 inch (102 mm) rigid metal or
semi-rigid metal transition ducting
of minimal length and turns
ˆ NO foil or plastic venting material
ˆ Approved vent hood exhausted to
outdoors
Leveling
ˆ Dryer is level, side-to-side and front-
to-back
ˆ Cabinet is sitting solid on all corners
Gas Supply (Gas Dryer)
ˆ Manual shutoff valve present in supply
ˆ All connections sealed with approved
sealer and wrench tight
ˆ Conversion kit for LP GAS system
# PCK4200 (not included) and must be
purchased separately
ˆ Gas supply turned on
ˆ No leaks present at all connections -
check with soapy water, NEVER check
with flame
Water Hookup (Select Models)
ˆ Inspect hoses for proper placement of
rubber washers
ˆ Water supply is turned on
PRE-INSTALLATION REQUIREMENTS
Installation Checklist
ˆ Check for leaks
ˆ Steam model dryers require use of
ASSEMBLY HOSE Kit #5304495002
(not included) and must be purchased
separately.
240v Electric Supply
(Electric Dryer)
ˆ Approved NEMA 10-30 or 14-30 service
cord with all screws tight on terminal
block
ˆ Approved strain relief installed
ˆ Terminal access cover installed before
initial operation
Door Reversal
ˆ Follow detailed instructions in this
manual
ˆ Test hinge and latch for function
Electrical Power
ˆ House power turned on
ˆ Dryer plugged in
Final Checks
ˆ Installation Instructions and Use & Care
Manual read thoroughly
ˆ Door latches and drum tumbles when
cycle starts
ˆ Registration card sent in
9
Advertisement
Table of Contents
