5.13 System information
This function gives the main information about the main body of the machine and the
firmware. The design changes when the firmware changes.
5.14 Backlit display
This allows it to be used in dark environments. The key
deactivate the backlight once the meter has been switched on. Because the EL light
consumes a lot of electricity, it should only be switched on when needed.
5.15 Auto Power Off
The Auto power off function can be set here. It can be selected between Off, 2 minutes,
5 minutes and 10 minutes.
5.16 System Reset
If the key is
pressed during machine start-up or if {System reset} is selected in the
menu, all settings and the memory are cleared and reset to default settings.
5.17 Battery information
Two AA alkaline batteries are required as energy source. After several hours of use,
the display shows the symbol
fuller the battery is. When the battery capacity is exhausted, the following symbol
appears
and starts flashing. The batteries should now be replaced.
The picture on the next page shows the position of the batteries in the device. When
changing the batteries it is essential to pay attention to the polarity.
Procedure:
1. Switch off the machine.
2. The battery cover is removed from the unit and the two batteries are removed.
3. The batteries are inserted correctly.
4. The battery cover is replaced.
5. The unit is switched on again for checking.
MT200
MiTec
18
. The larger the black portion in the symbol, the
Anode
Cathode
is used to activate and
TU_US-BA-e-2020