Table of Contents
Advertisement
1. In the {Test Set} → {Tolerance Limit} menu, press
command.
2. Use the and
measured value.
3. The key
is pressed again to confirm and enter the actual menu or the key
is pressed to cancel the limit setting.
4. If the set limit exceeds the measuring range, the meter will remind you to reset
the instrument. If the lower limit is greater than the upper limit, the values are
automatically replaced.
5.9 Resolution
The unit has two selectable screen resolutions, 0.1mm and 0.01mm. These can be
found in the menu under {Test Set}→ {Resolution}.
Use the key to
select between "high" (high resolution) and "low" (low resolution).
5.10 Unit scale
In the menu {Test Set}→ {Unit} the key is used to
inch (English).
5.11 Storage management
5.11.1 Saving a measured value
The measured values can be stored in the unit in 100 groups (F00-F99) and 100
measured values can be stored in each group.
The procedure is as follows:
1.
Press the key to display the {File name} menu.
2. Use the and
3. When a new reading appears, press
measurement to the current file. With the {Auto Save} function, the measured
value is automatically stored in the file as soon as a new measurement is added.
16
keys to
set the upper and lower limit value to the desired
keys to
select the appropriate group.
the key to activate the
select between mm (metric) and
the memory key to save the
TU_US-BA-e-2020
Advertisement
Table of Contents
