Table of Contents
Advertisement
displayed before the measurement screen appears. The unit has a special memory in
which all measurements are stored, even after the unit is switched off.
5.2 Probe selection
The measuring probe must be "preset" before the measurement. This serves as an
additional aid and enables the user to choose between the individual models the
correct measuring probe for the measurement requirements (frequency and diameter
dependent).
1. On the control panel,
measuring probe.
2. Press the
3. To exit,
press the key. The probe setting can also be changed in the menu,
see chapter 5.
5.3 Zero setting
The
key is used to zero the measuring instrument. If this is not done correctly, all
measurements taken may be incorrect.
When the unit is zeroed, the specified error value is measured and automatically
corrected for all subsequent measurements.
The procedure is as follows:
1. The unit must be switched on and the two-point calibration must be inactive.
The
Zero setting is not possible with this one.
2. The measuring probe is plugged in and the connections of the plugs
will be reviewed. The contact surface of the measuring probe must be clean.
3. The currently used measuring probe is displayed in the device
4. A drop of coupling agent is now applied to the metal zero plate.
5. The measuring probe is carefully pressed onto the zero plate.
6. While the measuring probe is now in direct contact with the zero plate through
the gel on the zero plate, the
while the instrument calculates the "zero point".
7. When the symbol ''ZER'' disappears, the probe is lifted from the zero plate.
TU_US-BA-e-2020
press the key (bottom left) several times to select the
key or the
key to display the different models.
.key is pressed. ZER" appears on the display
11
Advertisement
Table of Contents
