Quincy Compressor HP 15 Manual Use And Maintenance page 2

ENGLISH
ADDRESSES OF ASSISTANCE CENTRES
In the event of breakdown or malfunction of the machine, switch it off and do not tamper with it.
If repairs are needed, apply only to a technical assistance centre approved by the manufacturer and insist on the use of original spare parts.
Failure to comply with the above may endanger the safety of the machine.
INTRODUCTION
Keep this manual with care for future consultation; the use and maintenance manual is an integral part of the machine. Read this
manual carefully before carrying out any operations on the compressor unit.
The installation of the compressor unit and all operations involving it must be performed in conformity with the regulations in
force concerning electric plants and personal safety.
CHARACTERISTICS AND SAFETY PRECAUTIONS
MACHINE WITH AUTOMATIC START
Lock Out – Tag Out (LOTO): Open the power isolating switch and lock it with a personal lock. Tag the power isolating switch
with the name of the service technician.
BEFORE REMOVING THE PROTECTIVE GUARDS TO CARRY OUT ANY MAINTENANCE ON THE MACHINE, SWITCH OFF THE
ELECTRIC POWER SUPPLY AND DISCHARGE THE RESIDUAL PRESSURE INSIDE THE UNIT.
ALL WORK ON THE ELECTRIC PLANT, HOWEVER SLIGHT, MUST BE CARRIED OUT BY PROFESSIONALLY SKILLED
PERSONNEL.
THIS MACHINE IS NOT SUITABLE FOR EXTERNAL INSTALLATION
THIS MACHINE CORRESPOND TO THE ESSENTIAL SAFETY REQUIREMENTS FORESEEN FROM THE EUROPEAN STANDARD (2006/42
CE).
THE LUBRICATING LIQUIDS AND OTHER EVENTUAL FLUIDS MUST NOT BE DISCHARGED IN THE ENVIRONMENT. THESE POLLUTING
AND HAZARDOUS PRODUCTS MUST COMPULSORY BE DISPOSED BY CHARGING AUTHORISED AND SPECIALISED FIRMS
ACCORDING TO THE DIFFERENT TYPOLOGY OF PRODUCT.
DIFFERENTIATE THE COMPRESSOR COMPONENTS ACCORDING TO THE DIFFERENT CONSTRUCTION MATERIALS (PLASTIC,
COPPER, IRON, OIL FILTER, AIR FILTER ECC...)
The manufacturer does not accept responsibility for damage caused as a result of negligence or failure to abide by the instructions given above.
AIR RECEIVER AND SAFETY VALVE:
- To limit internal corrosion, which could compromise the safety of the compressed air tank, the condensation that is produced must be
discharged at least once a day. If an automatic drain fitted to the air receiver is present, it is necessary to check that it is working correctly
every week and repair it if necessary.
- The thickness of the receiver must be checked every year and also in accordance with legislation in force in the country where
the receiver is installed.
- The tank cannot be used and must be replaced if the thickness falls below the minimum level given in the instruction documents
for the tank.
- The tank can be used within the temperature limits given in the conformity declaration.
- The safety valves of the air receiver and oil receiver must be checked every year and replaced if necessary in
accordance with legislation in force.
NOT RESPECTING THE ABOVE MENTIONED PRESCRIPTION CAN RESULT IN AIR RECEIVER BURSTING HAZARD.
The manufacturer does not accept responsibility for damage caused as a result of negligence or failure to abide by the instructions given above.
2 - Edition 02/2018 Cod. 9828093052 04 -
MACHINE AND MANUFACTURER IDENTIFICATION DATA
1
1) Position of the identification plate