8.4 POSITION OF THE DATA PLATE FOR DRYER UND TANK
9.0 COMPRESSOR ROOM
9.1 FLOOR
The floor must be even and of industrial type; the total weight of the machine is shown in the Chap. 13.0
Remember the total weight of the machine when positioning it.
9.2 VENTILATION
When the machine is operating, the room temperature must not be higher than 46 °C or lower than 1 °C.
The volume of the room must be about 60 m
m
each. The first opening must be in a high position to evacuate the hot air, the second opening must be low to allow the intake of external
2
air for ventilation. If the environment is dusty it is advisable to fit a filtering panel on this opening.
9.3 EXAMPLES OF VENTILATION OF THE COMPRESSOR ROOM
10.0 TRANSPORT AND HANDLING
The machine must be transported as shown in the following figures.
11.0 UNPACKING
After removing the packing, ensure that the machine is unbroken and that there are no visibly damaged parts.
If you are in doubt, do not use the machine but apply to the manufacturer technical assistance service or to your dealer. The packing
material (plastic bags) must not be left within the reach of children or abandoned in the environment, as they are a potential source of
danger and pollution. Dispose of these materials in the approved collection centres.
.
Data plate
The room must be provided with 2 openings for ventilation with a surface area of about 0,5
3
Hot air pipe
Fan air
output
Cod. 9828093052 04 - Edition 02/2018 - 9
ENGLISH
FIG. 9
FIG. 10
FIG. 11