Removing Jammed Nails; Maintenance - Meec tools Multi Series Operating Instructions Manual

EN
4. Release the trigger and lift the nail gun so
that the safety switch releases and springs
out.
5. Repeat steps 2 and 3 to fire more
fasteners.
Contact Firing
Contact controlled firing is a rapid method,
suitable for big jobs.
1. Set the function selector to Contact Firing.
2. Press the trigger and hold.
3. Press the safety switch against the
workpiece to fire.
4. Keep the trigger pressed and lift the nail
gun so that the safety switch releases and
springs out.
5. Repeat step 3 to fire more fasteners. The
trigger must be held pressed in when
pressing in the safety switch.
6. Release the trigger during a pause in the
work to reduce the risk of unintentional
firing.

REMOVING JAMMED NAILS/

STAPLES
WARNING!
Stop working immediately if a nail or staple
jams in the nail gun. Remove the battery
from the nail gun. Remove the nail/staple
before resuming the work, otherwise the nail
gun can be damaged.
1. Release the battery from the nail gun.
2. Press in the magazine catch and pull back
the magazine casing, and empty all the
nails/staples.
3. Release and remove the jammed nail/
staple.
– If the jammed nail/staple cannot be
removed as above, use the supplied
hex key to undo the screws on the
plate.
30
– If necessary use pliers to remove the
jammed nail/staple. Replace the
plate and screw tight.
4. Slide the magazine casing to close it and
check that it clicks in place.
5. Replace the battery.
FIG. 7

MAINTENANCE

NOTE:
• Do not use strong detergents or solvents,
they can damage the plastic parts.
• Make sure that no water gets into the
nail gun.
• Always pull the plug out from the mains
before cleaning the battery charger.
• Keep the safety devices, ventilation
openings and the motor housing free
from dust and dirt.
• Wipe clean with a clean cloth, or blow
clean with compressed air at low pressure.
• Clean the nail gun immediately after
using it.
• Clean the nail gun at regular intervals
with a cloth moistened with water and a
mild detergent.
• Use a dry cloth to clean the battery
charger.