The Pyrolytic Cleaning Programme Is Cancelled - Miele H 2265-1 BP Operating And Installation Instructions

Cleaning and care
 Clean the oven compartment to
remove any pyrolytic residues (e.g.
ash) that may have built up
depending on the degree of soiling in
the oven.
Most residues can be removed with
warm water, a little washing-up liquid
and a clean sponge or a clean, damp
microfibre cloth.
Depending on the level of soiling, a
visible deposit can build up on the
glass on the inside of the oven door.
This can be removed with a
dishwashing sponge, a glass scraper
or a stainless steel spiral pad and a
little washing-up liquid.
The fibreglass seal around the front
of the oven should be handled
carefully. Do not rub and scour it.
Ideally, you should avoid cleaning it.
Enamelled surfaces can be
permanently discoloured by spilled
fruit juice. Such discolouration does
not affect the properties of the
enamel.
Do not attempt to remove these
marks.
62
The Pyrolytic cleaning programme is
cancelled
If the Pyrolytic cleaning programme is
cancelled, the oven door will remain
locked until the temperature inside the
oven drops to below 280 °C.  remains
lit up until the temperature of the oven
cavity has fallen below this temperature.
When  flashes, the door is unlocked.
The following will cause the Pyrolytic
cleaning programme to stop:
- The function selector is turned to a
different function or to the 0 position.
Turn the function selector back to the
Pyrolytic cleaning programme
position  if you want to restart the
programme.
- A power cut.
When power is restored,  remains
lit up until the temperature of the
oven cavity has fallen below 280 °C.
After that the numeric block will
appear,  will flash and the door will
unlock. Then  will flash in the
display.
 Confirm with OK if you want to start
the Pyrolytic cleaning programme
again. You can select the Pyrolytic
cleaning programme you want and
start it again.
As soon as you turn the function
selector to the 0 position following an
interruption to the power supply,
 will continue flashing. Confirm with
OK to enter the time of day again (see
"Before using for the first time").