Making A New Program - NUVE NF 1200 User Manual

07-STOP key

Stops the run by starting the braking phase manually.
08- LID key

Opens the lid if the lid indicator lights up.
09- LID Indicator Led

This led is on if the opening of the lid is possible.
10- START Indicator Led

This led turns on as the start button is pushed and turns off as the "Lid Indicator"(9) turns on
after the rotor has stopped spinning.
11-LID OPEN Indicator Led

It turns on if the lid remains open or is not properly closed.
12- Imbalance Indicator Led

It is activated if imbalance occurs. Brake is applied immediately.
13- Acceleration Indicator Led

It turns on while the acceleration rate is being programmed and while the rotor is accelerating.
14- Braking Indicator Led

This indicator turns on while the breaking rate is being programmed and while the rotor is
breaking.
15-Value Increase/Decrease Keys

They increase or decrease values during programming stage and to select the program
number during stand-by position. By pushing value increase key it is possible to see the set
values during centrifugation.
16- Function key

It is pushed to see the RPM or RCF value on the speed display during the run, to pass among
the displays and to store the programmed values.
17- Cooling Indicator Led*

It indicates that the cooling system functions. During programming, it indicates that the
temperature value is being set on Acc/Br/Temp Display (3).
* It is not valid for NF 1200 model.
4.3.

MAKING A NEW PROGRAM

Determine the rotor type, the speed and time, the acceleration and braking rates.

Push the function key (16) once and see that the value on the program no display (4) flashes.
Enter the program number by pushing the value increase and value decrease keys (15).

Push the function key (16) again and see that the value on the speed display (1) flashes.
Select the proper rotor type by pushing value increase and value decrease keys (15).
11