Programming; End Of The Program - NUVE FN 300 User Manual

10. Alarm Led: It lights up when the program ends and if any failure occurs during the
operation.

4.3.Programming

4.4. End of the Program

• See that the program is over.
• Take the samples out.
• Wipe the chamber surface to clean if needed.
• You may leave the dry air sterilizer / oven on stand-by position or switch it off.
Push the temperature set key.
Set the temperature by pushing the value
increase/decrease keys.
Push the temperature set key again to save the
temperature value.
Push the time set key.
Set the time values by pushing the value
increase/decrease keys (01 min. to 999 min. or
Hold)
Push the time set key again to save the value.
Push the start/stop key to start the program.
10