Making Program - NUVE NF48 User Manual

01- Status Display
This display shows the speed values (RPM or RCF) during programming. It also indicates
accelerating condition, braking condition, power failure condition, open lid condition and the
condition that occurs when Start is pressed while the lid is open by the expressions Acc, br,
E oFF, oPEn, cLoSE Lid, respectively. The error codes that occur in case of any failure
condition are also shown on this display.
02- Time Display
Display of the run time from 1 min. to 99 min. and hold position (H).
03- LID Key
Opens the lid if the lid indicator lights up
04- LID Indicator Led
It turns on if the lid remains open or is not properly closed.
05- ENCODER Button
This has two functional move. Turn clockwise and opposite clockwise, reach program menu,
set value and "READY" situation. By turning the Encoder button increase or decrease values
during programming stage. When Led is "READY" situation, by pushing Encoder button start
device. Stops the run by starting the braking phase manually.
06- READY Led
It indicates that the device ready to run.
07- RPM/RCF Key
Check the RPM or RCF value during the operation.
08- PULSE Led
It indicates that the user is on the program menu.
09- Set Menu Led
It indicates that the user is on the set value menu.
5.3.

MAKING PROGRAM

9