Section 7; Disposal Management Concept; Section 8; Troubleshooting - NUVE NF 1200 User Manual

The currently valid local regulations governing disposal must be observed. It is in the responsibility
of the user to arrange proper disposal of the individual components.
Applicable local regulations for disposal have to be carefully observed.
The instruments and electronic accessories (without batteries, power packs etc.) must be disposed
off according to the regulations for the disposal of electronic components.
Batteries, power packs and similar power source have to be dismounted from electric/electronic
parts and disposed off in accordance with applicable local regulations.
If the centrifuge fails to operate,
Check that,

The on/off switch is on,

The fuses are sound,

The plug is not defective,

The centrifuge is well connected to the supply,

The electricity installation is not defective,

Power is supplied.
In case of below written failures, related error codes are shown,
Err 2

Motor overheat. Please switch off the centrifuge for at least 20 minutes
Err 3

Speed failure. The optical sensor could have failed. Please observe whether the "running"
indicator leds are on or not. If it is not on, the optical sensor is defective. If it is on, the motor
could have failed. Contact to your service if either occurs.

This error code occurs when the mains voltage drops below the lower limit.
Err 4

Lid failure. This failure occurs when lid is opened during the centrifugation.
Err 5

The temperature sensor endings are broken. This error code appears only on NF 1200R.
Err 6

Motor failure. The motor driver unit (inverter) is defective. Switch off the centrifuge and switch
on again after the motor has stopped. If you still see the error code, contact to the service.
PLEASE CONTACT TO AN AUTHORIZED NUVE AGENT TO SEEK TECHNICAL HELP IF AN
ERROR OCCURS.

DISPOSAL MANAGEMENT CONCEPT

TROUBLESHOOTING

SECTION 7

SECTION 8

19