[Initial Startup]; [Startup Input Select] - Panasonic PT-RCQ10 Operating Instructions Manual

g When the power on <b> button is pressed
g When the operation to disable the shutter function (shutter: opened) is performed, such as pressing the <SHUTTER> button
g When the operating environment temperature is around 0 °C (32 °F) and the light source is forced to turn on due to warm-up
f The no signal lights-out function is disabled in following case.
g When [BACK COLOR] is set to [DEFAULT LOGO] or [USER LOGO], and the Panasonic logo or the image registered by the user is
displayed in the projected image
[NO SIGNAL SHUT-OFF]
This is a function to automatically set the power of the projector to standby mode when there is no input signal for
specific period. The time before switching to standby can be set.
1) Press as to select [NO SIGNAL SETTING].
2) Press the <ENTER> button.
f The [NO SIGNAL SETTING] screen is displayed.
3) Press as to select [NO SIGNAL SHUT-OFF].
4) Press qw to switch the item.
f The items will switch each time you press the button.
[DISABLE]
[10MIN.] - [90MIN.]

[INITIAL STARTUP]

Set the startup method when the <MAIN POWER> switch is set to <ON>.
1) Press as to select [INITIAL STARTUP].
2) Press qw to switch the item.
f The items will switch each time you press the button.
[LAST MEMORY]
[STANDBY]
[ON]

[STARTUP INPUT SELECT]

Set the input when the projector is switched on to start projection.
1) Press as to select [STARTUP INPUT SELECT].
2) Press the <ENTER> button.
f The [STARTUP INPUT SELECT] screen is displayed.
3) Press asqw to select the input, and press the <ENTER> button.
[LAST USED]
[HDMI]
[DVI-D]
[SDI]
[DIGITAL LINK]
[INPUT1] - [INPUT10]
[HDMI1 [SLOT]]
*2
[HDMI2 [SLOT]]
*2
[DVI-D1 [SLOT]]
*2
[DVI-D2 [SLOT]]
*2
[SDI1 [SLOT]]
*2
[SDI2 [SLOT]]
*2
[SDI3 [SLOT]]
*2
[SDI4 [SLOT]]
*2
[DisplayPort1 [SLOT]]
Chapter 4 Settings — [PROJECTOR SETUP] menu
Disables the no signal shut-off function.
Sets the time in increments of 10 minutes.
Starts up the projector in the condition before the <MAIN POWER> switch is set to <OFF>.
Starts up the projector in standby.
Starts projecting immediately.
Keeps the input selected last.
Sets the input to HDMI.
Sets the input to DVI-D.
Sets the input to SDI.
Sets the input to DIGITAL LINK.
Sets the input to DIGITAL LINK, and switches the input of the Panasonic twisted-pair-cable
*1
transmitter to the specified input.
Sets the input to HDMI1 of the Interface Board.
Sets the input to HDMI2 of the Interface Board.
Sets the input to DVI-D1 of the Interface Board.
Sets the input to DVI-D2 of the Interface Board.
Sets the input to SDI1 of the Interface Board.
Sets the input to SDI2 of the Interface Board.
Sets the input to SDI3 of the Interface Board.
Sets the input to SDI4 of the Interface Board.
Sets the input to DisplayPort1 of the Interface Board.
*2
ENGLISH - 155