[Status] - Panasonic PT-RCQ10 Operating Instructions Manual

2) Press the <ENTER> button.
f The [FUNCTION BUTTON] screen is displayed.
3) Press as to select a function.
[DISABLE]
[SUB MEMORY]
[SYSTEM SELECTOR]
[SYSTEM DAYLIGHT VIEW]
[FREEZE]
[WAVEFORM MONITOR]
[ASPECT]
[PROJECTION METHOD]
[GEOMETRY]
[OSD POSITION]
4) Press the <ENTER> button.
Note
f The [FUNCTION BUTTON] screen can also be displayed by holding down the <FUNCTION> button on the remote control.

[STATUS]

Display the status of the projector.
1) Press as to select [STATUS].
2) Press the <ENTER> button.
f The [STATUS] screen is displayed.
3) Press qw to switch the pages.
f The page will change each time you press the button.
[PROJECTOR TYPE]
[SERIAL NUMBER]
[PROJECTOR RUNTIME]
[LIGHT RUNTIME]
[CONTINUOUS LIGHTING
TIME]
[MAIN/SUB VERSION]
[INTAKE AIR TEMP.]
[OPTICS MODULE TEMP.]
[EXHAUST AIR TEMP.]
[LIGHT1 TEMP.]
*1
[LIGHT2 TEMP.]
*1
[SELF TEST]
[INPUT]
[SIGNAL NAME]
[MEMORY NO.]
[BACKUP INPUT STATUS]
[NUMBER OF REGISTERED
SIGNAL]
[COOLING CONDITION]
[ATMOSPHERIC PRESSURE] Displays the atmospheric pressure.
[REMOTE2 STATUS]
Chapter 4 Settings — [PROJECTOR SETUP] menu
Disables the <FUNCTION> button.
Displays the sub memory list. (x page 172)
Switches the [SYSTEM SELECTOR] setting according to the input signal of the image being
projected.
f When the input signal is anything other than the SDI input
The [PICTURE] menu → [SYSTEM SELECTOR] (x page 98)
f When the input signal is the SDI input
The [DISPLAY OPTION] menu → [SDI IN] → [SYSTEM SELECTOR] (x page 123)
Switches the [SYSTEM DAYLIGHT VIEW] setting. (x page 96)
Freezes the image temporarily. (x page 139)
Displays the waveform of the input signal. (x page 139)
Switches the aspect ratio of the image. (x page 101)
Switches the [PROJECTION METHOD] setting. (x page 141)
Switches the [GEOMETRY] setting. (x page 103)
Switches the [OSD POSITION] setting. (x page 133)
Displays the type of the projector.
Displays the serial number of the projector.
Displays the runtime of the projector.
Displays the runtime of the light source 1 and the light source 2.
Displays the elapsed time from when the light source is illuminated.
The elapsed time after the illumination of the light source can be confirmed when adjusting the focus.
The elapsed time is reset when the light source is temporarily turned off such as using the shutter
function.
Displays the main and sub versions of the firmware of the projector.
Displays the status of the intake air temperature of the projector.
*1
Displays the status of the internal temperature of the projector.
*1
Displays the status of the exhaust air temperature of the projector.
*1
Displays the status of the light source 1 temperature of the projector.
Displays the status of the light source 2 temperature of the projector.
Displays the status of the projector.
Displays the input terminal currently selected.
Displays the input signal name.
Displays the memory number of the input signal.
Displays whether switching to the backup input signal is possible or not when [BACKUP INPUT
MODE] is set to [OFF]. (x page 118)
Displays the number of registered signals.
Displays the set cooling conditions.
Displays the control status of the REMOTE2.
ENGLISH - 163