Attaching The Projection Lens - Panasonic PT-RCQ10 Operating Instructions Manual

Chapter 2 Getting Started — Removing/attaching the projection lens

Attaching the projection lens

Attach the projection lens using the following procedure.
Guide groove
Projection lens
Fig. 1
1) Remove the Lens Mount Cover, and align the projection lens guide to the guide groove of the
projector and insert to the end. (Fig. 1)
2) Turn the projection lens clockwise until it clicks. (Fig. 2)
3) Attach the Lens Mount Cover. (Fig. 3)
f Align the Lens Mount Cover and the projector at the dashed line positions in the figure to attach, and turn
the Lens Mount Cover clockwise to fix it to the projector.
Attention
f Turn the projection lens counterclockwise to confirm that it does not come out.
f After attaching the projection lens, turn on the projector and confirm the [LENS TYPE] setting. Change the setting if the type does not match
the projection lens attached to the projector. (x page 79)
Guide
Lens Mount Cover
Fig. 2
(i)
(ii)
Fig. 3
ENGLISH - 53