[Data Cloning]; [Save All User Data] - Panasonic PT-RCQ10 Operating Instructions Manual

[HDCP STATUS]
Note
f Pressing the <ENTER> button while [SIGNAL INFORMATION] in the 5/5 page of the [STATUS] screen is displayed will display the
[DETAILED INFORMATION] screen, and detailed information of the input signal can be displayed. Information for multiple input signals may
be displayed depending on the projected image. Press qw to switch pages.
f Some items in [SIGNAL INFORMATION] and [DETAILED INFORMATION] may be displayed and others not displayed, depending on the
signal being input.
f If any abnormality has occurred on the projector, press the <DEFAULT> button while the [STATUS] screen is displayed to display the detail
screen of the error information.
f For details on the contents displayed in [SELF TEST], refer to "[SELF TEST] indications" (x page 229).
Sending status content via E-mail
The status content can be sent to the E-mail address (up to two addresses) set in "[E-mail set up] page"
(x page 203).
1) Press the <ENTER> button while the 1/5 to 4/5 page of the [STATUS] screen is displayed.
2) Press as to select [SEND E-MAIL].
3) Press the <ENTER> button.
f The [SELECT E-MAIL ADDRESS] screen is displayed.
4) Press as to select the destination.
5) Press the <ENTER> button.
f The confirmation screen is displayed.
6) Press qw to select [OK], and press the <ENTER> button.
f The status content is sent.
Saving status content in USB memory
The status content can be saved in a USB memory attached to the <USB> terminal.
1) Press the <ENTER> button while the 1/5 to 4/5 page of the [STATUS] screen is displayed.
2) Press as to select [SAVE TO USB MEMORY].
3) Press the <ENTER> button.
f The confirmation screen is displayed.
4) Press qw to select [OK], and press the <ENTER> button.
f The status content is saved.

[DATA CLONING]

Perform the operation of the data cloning function. Data such as the settings and adjustment values of the
projector can be copied to multiple projectors via LAN or using the USB memory.
For details of operation, refer to "Using the data cloning function" (x page 212).

[SAVE ALL USER DATA]

Save the various setting values as a backup in the built-in memory of the projector.
1) Press as to select [SAVE ALL USER DATA].
2) Press the <ENTER> button.
f The [SECURITY PASSWORD] screen is displayed.
3) Enter a security password and press the <ENTER> button.
f The confirmation screen is displayed.
Chapter 4 Settings — [PROJECTOR SETUP] menu
Displays the HDCP status of the input signal. The content of display is as follows.
[HDCP2.2]: When protected with HDCP 2.2
[HDCP1.X]: When protected with HDCP 1.X
[NONE]: When not protected with HDCP
[---]: When there is no signal
ENGLISH - 165