[Edge Blending] - Panasonic PT-RCQ10 Operating Instructions Manual

Blanking correction
Left side of the
screen
Right side of the
screen
Note
f The upper limit of the adjustment range may be restricted so that the entire projected image is not covered by blanking width.

[EDGE BLENDING]

The edge blending function allows multiple images to be seamlessly overlapped by using the inclination of the
brightness at the overlapped area.
It is recommended that edge blending is adjusted after an image is projected continuously for at least 30 minutes
and then the image is stable.
1) Press as to select [EDGE BLENDING].
2) Press qw to switch the item.
f The items will switch each time you press the button.
[OFF]
[ON]
[USER]
f Proceed to Step 3) when anything other than [OFF] is selected.
3) Press the <ENTER> button.
f The [EDGE BLENDING] screen is displayed.
4) Press as to specify the location to be corrected.
f When joining at top: Set [UPPER] to [ON]
f When joining at bottom: Set [LOWER] to [ON]
f When joining at left: Set [LEFT] to [ON]
f When joining at right: Set [RIGHT] to [ON]
5) Press qw to switch to [ON].
6) Press as to select [START] or [WIDTH].
7) Press qw to adjust the starting position or correction width.
8) Press as to select [MARKER].
110 - ENGLISH
Chapter 4 Settings — [ADVANCED MENU] menu
Item Operation
Press w.
[LEFT]
Press q.
Press q.
[RIGHT]
Press w.
Sets the edge blending function to off.
Use the setting value preset in the projector for the inclination of the edge blending area.
Use the user-setting value for the inclination of the edge blending area. (Configuration/registration
requires separate software. Consult your dealer.)
Adjustment
The blanking zone
moves to the right.
The blanking zone
moves to the left.
The blanking zone
moves to the right.
The blanking zone
moves to the left.
Range of adjustment
Left and right 0 - 1 918