Scanning Thin Documents - Fujitsu FI-5530C2 Operator's Manual

2.3

Scanning Thin Documents

When you scan a batch of thin documents (which are out of specifications with under 52g/m ² of
thickness), document jams (Multifeed) and mis-picking may occur. If you have to scan such docu-
ments, switch the lever to "Thin" side.
1. Make sure that the thin documents meet the requirements described in section
Document Quality" on page
2. Shift the position of the paper thickness switch to the "Thin" position (the factory
default is "Normal" position).
3. Scan the documents, following the procedure in section
(page 10).
For information about how to scan documents, refer to section
PRO" on page
ATTENTION
48
133.
Paper Thickness Switch
29.
Move the Paper Thickness Switch to "Normal" position when scanning
documents of standard thickness. Move the switch to "Thin" position only
when you scan thin paper, which is of non-standard thickness (less than
2
52g/m ).
Note that feeding performance may be degraded when you scan
documents of non-standard paper.
"1.3 Scanning Documents"
"1.5 How to Use ScandAll
"6.2