Fujitsu FI-5530C2 Operator's Manual page 23

4. Place the document on the ADF paper chute.
Set the document face-down in the ADF paper chute (so that the side to be scanned faces
toward the ADF paper chute).
This scanner can scan ID cards through the ADF with the following
ATTENTION
precautions.
•
Place one card at a time into the ADF.
•
ID card feeding requires the card to be fed through the ADF in portrait
mode as in the following figure.
•
Smooth cards should be placed face down in the ADF.
•
The card to be scanned should be within the ISO7810 compliance, type
ID-1.
ISO7810-compliant, Type ID-1 card
Material: PVC (Poly vinyl chloride) or PVCA (Polyvinyl chloride acetate)
Dimensions: 3.4 inch (height) x 2.1 inch (width) / 86 mm x 54 mm
Thickness: 0.03 ± 0.003inch / 0.76 ± 0.08mm
•
Embossed cards (on which a raised effect is created) cannot be scanned.
•
Cards that are excessively rigid or less flexible may not feed smoothly
and excessive noise may occur.
•
Cards should be clean from oil and without labels.
•
Cards cannot be scanned when the imprinter is installed.
1.2 Placing Documents on the ADF
Load the documents facing the ADF
paper chute.(face down)
fi-5530C2 Image Scanner Operator's Guide
LANDSCAPE
7
1