Fujitsu FI-4860C2 Operator's Manual page 279

At this screen, press
and select scan resolution. Following parameters can be specified.
200:
240:
300:
400:
Press (Enter button) and confirm the setting. Then <Screen51-2> is
redisplayed.
(5) Press (Enter button). Then <Screen51-1> is redisplayed.
At <Screen51-1>, select [START] and press
If fi-486PRFR and/or fi-486PRREis installed, <Screen51-3> is displayed
for setting imprinter test conditions.
If an imprinter(s) is not installed, the scanner starts scanning operations.
6) At this screen, press
Select [On] to do imprinter test while scanning.
Then, select the imprinter to use.
If the printer to use is fi-486PRFR, select [Pre].
If fi-486PRRE, select [Post].
If imprinter test is not required, select [Off].
(Left arrow button) or
Scan at 200 dpi
Scan at 240 dpi
Scan at 300 dpi
Scan at 400 dpi
<Screen51-3>
P r
= O f f / O
(Left arrow button) or
(Right arrow button)
(Start button).
i n t
n : P r e / P
(Right arrow button) and:
7.5 Test Mode Details
7
o s t
7-79