Fujitsu FI-4860C2 Operator's Manual page 253

24. Selection of Imprinter
In this scanner, you can install the Pre- and Post-imprinters (optional
accessories). However, you cannot use both imprinters simultaneously. The
following procedure describes how to select the imprinter you want to use.
1) Press (Next button) or
on the LCD panel.
2) At <Screen24>, press
select the imprinter you want to use.
The blinking item is the one selected.
When "Pre" is blinking: the Pre-imprinter (fi-486PRFR) is selected
HINT
When "Post" is blinking: the Post-imprinter (fi-486PRRE) is selected.
3) Press (Enter button) to confirm the setting. Then configure the priority
setting. The <Screen24-1> is displayed.
The imprinter selection can be specified from the interface or the operator
panel. The priority setting is to decide which setting the scanner must follow;
the setting done on the interface or the operator panel
(Previous button), and display the <Screen24>
<Screen24>
4
! 2 I m
e
S l e c t
(Left arrow button) or
If "Pre" is selected at <Screen24>:
<Screen24-1>
4
! 2 - 1
= I / F /
If "Post" is selected at <Screen24>:
<Screen24-1>
4
! 2 - 1
= I / F /
p r i n t e r
P /
r e P
(Right arrow button) and
P r i o r i t
P e : P
a n l
P r i o r i t
P e : P
a n l
7.3 Setup Mode Details
7
o s t
y
e
r
y
s
o t
7-53