Fujitsu FI-4860C2 Operator's Manual page 221

3) At <Screen 4-1> you can enable or disable the Double-feed detection or
configure the detection modes by pressing
arrow button).
By pressing (Right arrow button), the selection moves from (1) to (3).
By pressing (Left arrow button), the selection moves from (3) to (1).
(1) [Off] is blinking:
(2) [On] and [1] are blinking:
(3) [On] and [2: Full] are blinking:
4) At <Screen 4-2> you can set the detection range for Double-feed by checking
document overlapping. Press
to set the start and end positions for the detection.
(1) [Top] is blinking:
(2) [L] is blinking:
Press (Next button) or
the selected item. To enable the settings, press
<Screen4-1>
! 0 4 - 1 U
= O f f / O n
Document overlapping is not checked.
Document overlapping is checked for
the range set at step 4). This mode is
used for preventing mis-detection when
scanning documents that are pasted
photos, etc.
Document overlapping is checked for
the whole area of the
documents.(Default setting)
(Left arrow button) or
<Screen 4-2>
! 0 4 - 2 S
T o p : 0
The start position for the detection is set.
The detection is range set.
(Previous button) to increase/decrease the value of
(Right arrow button) or
l t r a s o n
-> 1 / 2 : F u
(Right arrow button)
U S r a n g
L : 1 0 0
(Enter button).
7.3 Setup Mode Details
(Left
i c
7
l l
e
m m
7-21