Fujitsu FI-4860C2 Operator's Manual page 260

27. Setting Power save mode
1) Press (Next button) or
<Screen27>.
2) At <Screen27>, press
select [On] to use power save mode.
Next, press
If power save mode is not required, press
[Off].Then, press
3) At <Screen27-1> ,by pressing
button), select the scanner wait idle time before entering power save mode.
HINT
A minimum of 5 minutes to the maximum of 60 minutes can be selected with 5
minutes increment.
HINT
4) Press
press
7-60
7.3 Setup Mode Details
(Previous button) and let LCD display
<Screen27>
! 2 7
=
(Left arrow button) or
(Enter button). Then the LCD display shows <Screen27-1>.
(Enter button).
<Screen27-1>
! 2 7 -
= 1
The blinking item is the one selected.
The default time recommended by the ENERGY STAR
utes.
(Enter button) and enable to use power save mode. Finally,
(Exit button) and the LCD display goes back to [Ready] screen.
P o w e r S
(Right arrow button)and
(Right arrow button) and select
1 T i m e
0 1 5
(Left arrow button) or
a v e
2 0 m i n
(Right arrow
®
program is 15 min-