Checking Gmac Communication - Gamatronic uPS 3:3 Phase Series User Manual And Instruction Manual

User Guide
Screen 9: Completing
the Network Card
Configuration Wizard
Appears after the data is
received by the card.
Click Finish to end the
card configuration.
After configuring the card:
Lower the left DIP SWITCH circuit breaker to working mode.
1.
Ping the card's configured IP address to check it.
2.
10.3.4

Checking GMaC Communication

To check that the GMaC is communicating properly:
In the Start menu, click Run.
1.
In the Open field, type: command.
2.
In the Command window, type: ping 192.168.0.182.
3.
Three data packages are sent to the GMaC.
If the three Request time out messages are returned:
4.
•
Check the connection to the GMaC
•
Verify that the computer's IP address is in the same IP Zone as the
GMaC's.
If there is a reply (i.e. 'Reply from 192.168.0.182: bytes =32 time<10ms
5.
TTL=255'), the configuration is successful.
Note: We highly recommend that you record all IP configuration settings and store
them in a readily accessible place.
In the event that configuration settings are lost, you must reconfigure the GMaC step-
by-step, using an RS232 communication cable, using the Network Card
Communication Wizard, as explained above.
Page 60
Gamatronic Electronic Industries Ltd.
µPS Series 3:3 Phase 10kVA (GEMS)